Corrosion-resistant, powder coated epoxy finish. No sheet metal parts to rust or corrode. Stainless steel screws, switch arm, guard and handle. Watertight, neoprene square ring between motor and pump housing.
Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor. Upper and lower sleeve bearings running in bath of oil. Entire unit pressure-tested after assembly.
Carbon and ceramic shaft seal. Maximum temperature for effluent or dewatering: 130 °F (54 °C). Passes 1/2 (12 mm) spherical solids.
On point: 7-1/4 (18 cm). Off point: 3 (8 cm). Major width: 10-3/32 (26.2 cm).
Major height: 10-1/16 (25.6 cm). 3 HP Volts: 115 V Hertz: 60 Hz RPM: 1550 RPM PHASE : 1ph Impeller Type: Non-clogging vortex impeller Cord Length: 10 ft. Standard automatic Cord Type: UL listed, 3-wire grounded plug.